[. . . ] If your shaver does not come with a Jet Clean System, it refers to the shaver only. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. These appliances are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliances. [. . . ] - The shaving unit symbol, the tap symbol and the exclamation mark continue to flash until you unblock the shaving heads. If you have a heavy beard, the shaving time may be less than expected. The shaving time may also vary over time, depending on your shaving behaviour and beard type. Charge the shaver before you use it for the first time and when the display indicates that the battery is almost empty (see section `Battery low' in chapter `The display'). Quick charge After the shaver has charged for 5 minutes, it contains enough energy for one shave. Charging in the Jet clean system (specific types only) 1 Put the small plug in the Jet Clean System. 3 Place the shaver upside down in the holder with the display pointing towards the front of the Jet Clean System (Fig. Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit. Note: RQ12858590 only: when you turn the shaver upside down, the minutes indication on the display is also turned upside down so you can still see to what level the battery is charged. 4 Press the shaver tightly into the holder to lock it into place (Fig. Using the shaver shaving 1 Press the on/off button once to switch on the shaver. Then press the shaving unit downwards (2) to attach it to the shaver (`click') (Fig. 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). 5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines (Fig. Using the Jet clean system Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid (Fig. The cleaning light flashes throughout the cleaning program, which takes a few minutes. , During the first phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down. , During the second phase of the cleaning program , the shaver is placed in the drying position , indicated by the flashing drying symbol. 36) Note: RQ1008:The drying phase takes 1 hour when you have selected the eco program. , After the cleaning program , the charging indication appears on the shaver display (see chapter `The display'). Note: If you press the on/off button of the Jet Clean System during the cleaning program, the program aborts. [. . . ] In this case, the shaver does not work and the exclamation mark on the display flashes. Press the on/off button for 3 seconds to deactivate the travel lock. Clean the shaving unit or replace it (see chapters `Cleaning and maintenance' and `Replacement'). As soon as the temperature of the shaver has dropped sufficiently, you can switch on the shaver again. [. . . ]